it looks like you are going into pe after about 4sec of WOT. maybe there is some delay value somewhere??
it looks like you are going into pe after about 4sec of WOT. maybe there is some delay value somewhere??
04 VY Commodore ute M6 ls1, 918 valve springs, TR6 plugs, genttrbb twin turbo kit, 60lb seimiens injectors, Bosh 044 fuel pump, SX fuel reg, PLX wideband,Full Castle Hill Exhaust with 2 1/2in dump pipes, 4in cats into twin 3in cat back (no merge), Ripshift, oz700 clutch and 3.73 diff gears
yeah, most trucks have a delay in seconds...usually the RPM enable will cancel that out...usually.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
also i noticed that you have STFT enabled in open loop. have you tried it with this disabled??
When you go WOT your LTFT do lock at 0 and only your STFT have values so it does looks like you are going into open loop .....but not??? im confused
04 VY Commodore ute M6 ls1, 918 valve springs, TR6 plugs, genttrbb twin turbo kit, 60lb seimiens injectors, Bosh 044 fuel pump, SX fuel reg, PLX wideband,Full Castle Hill Exhaust with 2 1/2in dump pipes, 4in cats into twin 3in cat back (no merge), Ripshift, oz700 clutch and 3.73 diff gears
My 05 doesn't have a problem going into PE. I just checked today and I from a dead stop, PE will kick in at 1061 RPM. Enable torque is set at factory 100% and the delay RPM set to 1500.
2005 1500 CC Z71
1997 Pontiac Grand Prix
Here's a screen shot of my log.
2005 1500 CC Z71
1997 Pontiac Grand Prix
Most 05+ trucks (not all) have this problem. The fix has allways been to set the Enable Torque to 0 for all the trucks that wont enter PE. Your log file with Enable Torque at 50% seems to be just that.... Post up the fix when you figure it out.
hmm...possibly something to do with electronic throttle? I have an 06 and everything so far has been just peachy, especially as far as PE goes.
put it at 0 and same thing.
I had the same problem with a 2006 3500. Would not go into open loop.
Setting the Enable Torque to 0 fixed it.
FUEL - Power Enrich - ENABLE - Enable torque