FSCM Tuning 2013 ZL1

[Vicster]

Hello,
I have read this thread all the way through but it did not mention my issue.

https://forum.hptuners.com/showthrea...ro-LS3-vs-ZL1/

After flashing my FSCM I get a DTC code #P0603 (Kam) memory issue. It is logged as permanent.
Anyone know how to fix this issue, other than turning off the DCT code SES? It should not be tripping a code...

Here is a copy of my FSCM tune, 2013 ZL1.

FUEL CONTROLLER 05.09.19.hpt

[10_SS]

How long have you had it? Did it go away? Google showed someone else had it after a dead battery.

https://www.camaro5.com/forums/showthread.php?t=204025

This one says keep the driver door open while flashing?? veee8 says he's had the same thing on a 2013 also.
https://forum.hptuners.com/showthrea...pple-MIL-P0603

[RobZL1]

I had it. When I went from an SCT device to HPT, it was there but went away with time. As long as the cause of the error goes away, the permanent codes will eventually go away, too.

[Vicster]

How long have you had it? Did it go away? Google showed someone else had it after a dead battery.

https://www.camaro5.com/forums/showthread.php?t=204025

This one says keep the driver door open while flashing?? veee8 says he's had the same thing on a 2013 also.
https://forum.hptuners.com/showthrea...pple-MIL-P0603

Hello,
It showed up after flashing the FSCM with my ID850 data. Still have it as I have not driven the car.

Will try flashing with door open tonight and see if that takes care of it.

Thank you for the replies, Victor

[Vicster]

Hello,
It showed up after flashing the FSCM with my ID850 data. Still have it as I have not driven the car.

Will try flashing with door open tonight and see if that takes care of it.

Thank you for the replies, Victor

Well flashing it with the door open did not erase it, will see if driving it for awhile does...

[Vicster]

Well flashing it with the door open did not erase it, will see if driving it for awhile does...

Well, after a couple of starts was able to delete the code. All good, thank you for the replies!!

Victor

[marksrig]

Well, after a couple of starts was able to delete the code. All good, thank you for the replies!!

Victor

Hey Vic,

I'm posting here instead of sending a PM so you can review the thread in case you forgot the details.

I got this code today after doing a WRITE ENTIRE to clear some codes that were being difficult.

I see your P0603 finally fell off after a few days, but did you get the code because your did a WRITE ENTIRE or do you only WRITE CALIBRATION?

This was the first time I wrote the entire file ECM & FPCM. I fixed my problem but now I have this one.

Thanks friend,
Mark

[ABADZL1]

Incomplete programming of a module for more than 10 seconds is what sets this DTC. Very common on camaros when flashing the FSCM with all the other modules together. I like to flash the FSCM bye itself to prevent the DTC.