Hey guys...
So I'm still a bit green and poking my way through dialing in this jeep. Open loop is just about right and now I'm wanting to bring closed loop back into the equation. I'm trying to figure out what commands the ecu to go into open loop. Right now, I have closed loop disabled all together.
The setup on this jeep builds boost easily under light load on hills and such... so I would like it to go into open loop without going WOT.
Is power enrichment using the open loop base table? Would I just alter the MAP threshold for power enrichment?
Here is the stock file from the Jeep. I noticed that with the latest editor update, I can disable closed loop at certain RPM now which sorta helps... but not completely. It would be nice if it could be done via throttle position or MAP value.
Thanks
Stock.hpt