So I was able to flash prefix version 1003 on my 2015 Q5 TDI tonight. It's amazing to have it back like it was before !
Inkedimage_LI.jpg
So I was able to flash prefix version 1003 on my 2015 Q5 TDI tonight. It's amazing to have it back like it was before !
Inkedimage_LI.jpg
Does anyone have the 1001 pre-fix file for a 2014?
Reverted my Q5's TCU firmware to a 1003 revision and all is well; cold start shifting issues banished. Engine braking while present during warmup remains weaker than I remember and especially so during the normal drive cycle. For now my attention will be directed to an ECU reversion upon which a Malone stage2 will be applied.
Cheers to mmmzon for all the assistance.
old thread i know but did anyone ever figure this out?
how does one flash a 1003 file? ODIS?
Can we use the HPT cal to get a close enough calibration?
I have a 2013 audi q7 that I just bought and don't like how the trans operates at all! I like this thread although would someone care to share their stock pre file please. Would like to look through it. Or maybe redirect me to where one is already.
Thank-you!
Does this reading of the HPT "Calibration Only" apply to the other ZF8HP controllers as well? Or just VAG controllers? More specifically does HPT Read the entire TCM on Dodge ZF controllers?
Bc I've been wanting to try a similar thing where I saved a Tuned File off my Ram truck with HPT. And the Dealership wrote over my TCM to perform a recall.
But the Tuned file was applied with a PowerGate3 flash tool, and most certainly has changes made that HPT does not have access to some of the modified Maps.
Id love to use HPT to Re-Flash that Entire TCM file, Mainly to gain Manual Shifting back, But wasn't sure if HPT has the ability to Write the Entire file, And now reading your post, I'm not sure if HPT actually Read the Entire File off the RAM ZF TCM.