Hi all,

Im working on a LS swapped vehicle using a 2000 Corvette LS1, drive by wire throttle control, 6 sped manual trans, using the stock 2000 corvette computer. Car starts and runs, no issues there. My issue is when driving the car, the throttle cracker table will not enable, causing a dying problem when letting off the gas. I assumed this could be if the pcm thinks the clutch is in, since on a c5 OS, when clutch in, the throttle cracker table disables. After some research, it appears this car gets the clutch position from the BCM from the factory.

Anyone ever run into an issue like this before? I was going to try telling the pcm the car is an automatic since it doesn't utilize the reverse lockout or skip shift anyways. Any other parameters the pcm may need for the throttle cracker to enable? The pcm is getting a speed signal. Throttle follower works as it should.


Thanks!