Hello
I just got finished installing a vortec supercharger on a customers escalade 6.2. I swapped out the map sensor for the gm 2 bar. This set up runs without maf and open bov. I understand that I have to upload and rewrite the entire file to switch over to a speed density only setup, but no matter what I do, I can not get this thing to even idle. Starts up, shuts off. Over and over. Any ideas as to what I can check? I?m pretty sure I flashed it correctly because at least it?s starting. Thank you so much in advance for any insight you may be able to give.
Jason