-
Tuner in Training
MAF Logging?
I need some help that I can seem to figure out.
On MAF tuning it uses Period m/s, where am I able to log this? I was using BYT's layout, but looking at the MAF 1/2 tables there, it only fills in the very first block.
-
Senior Tuner
Make sure you are logging MAF Sensor period 1 and 2 in your channels list. Also, check the graph properties and make sure the settings match this screenshot
MAF.png
-
Tuner in Training
Roger that, will give it a go.
My trims at idle are skyhigh, like in the 25-30's, but cruising it's perfectly fine +/- 5.
I had to scale the IPM table down a little bit for the larger injectors, the limit of it seems to be about .9. So a little bit of MAF tuning at idle, and we should be good to go hopefully
-
Senior Tuner
Just watch because some of the idle cells are - values and won't adjust correctly doing copy/paste special from the chart in the logger. It will end up moving the value in the wrong direction!
-
Tuner in Training
So how do you treat the (-) value? Manual multiplication at each cell?