Results 1 to 5 of 5

Thread: Basic parameters in the log

  1. #1
    Tuner in Training
    Join Date
    Jun 2017
    Posts
    12

    Basic parameters in the log

    Hello everyone, how can I include parameters in graphs in the chart x time in my log?

    In the basic configuration it does not show RPM, KR, inj duty (%)

    Can anyone help me with this?
    Attached Files Attached Files

  2. #2
    Tuning Addict 5FDP's Avatar
    Join Date
    May 2012
    Location
    Rogers, MN
    Posts
    8,904
    Anything you wish to log must be present in the main channels list.

    I see that RPM is there but it's not populating at the moment. You should remove that channel, then re-poll for supported parameters and add it back into the main channels list. Then add knock retard, injector pulse width avg. Injector duty cycle is a math of the pulse width and will shows up when you add that channel.

    Also things like commanded AFR, you can add that channel too.

    If something doesn't seem to be working even after adding in the channel, contact support directly so they can look into a possible issue.
    2016 Silverado CCSB 5.3/6L80e, not as slow but still heavy.

  3. #3
    Tuner in Training
    Join Date
    Jun 2017
    Posts
    12
    thank you.

    I'll try to do this

    All the best

  4. #4
    Tuner in Training
    Join Date
    Jun 2017
    Posts
    12
    Hi, I tried this but it did not work...

  5. #5
    Tuning Addict 5FDP's Avatar
    Join Date
    May 2012
    Location
    Rogers, MN
    Posts
    8,904
    Then contact support.
    2016 Silverado CCSB 5.3/6L80e, not as slow but still heavy.