Hellcat Uconnect power level figure

[TonytotheB]

Hey folks

Does anyone know how to change the default "horsepower" level that's displayed in Uconnect? I believe it's done via the tune. Or do you think it's a tuner secret. I'd love mine to display my actual power



Cheers

[spoolboy]

That?s not coming from the PCM, the numbers that change in SRT pages or the dash display are calculated from the torque model though.

[TonytotheB]

That?s not coming from the PCM, the numbers that change in SRT pages or the dash display are calculated from the torque model though.

Fair enough dude. I was wrong with both suggestions haha

[Homer]

You can change the indicated torque by making changes to these tables...although I noticed some PCMs don't display the table for maximum indicated torque (shows up on a manual challenger but not an automatic). Although like spoolboy stated, I don't think it will change what is displayed on uconnect but I believe it does effect the expected torque display through VCM scanner (don't remember off hand).

torque.JPGindicated torque.JPG