Hey what?s up everyone, I?m having trouble tuning my V. I am currently doing a everything I can think of but I?m stuck. The car only has a couple bolt ons: ported ls3 TB, airaid intake, and full exhaust with cooling mods. I started with a MAF tune by turning off all the necessities like DFCO, PE, COT, etc. then once my numbers were within 5% I switched to tuning the VVE. (I made the necessary change in my scalar value for the larger TB.) I then disconnected the MAF (physically and set frequency to 0) along with disabling DFCO, PE and COT and codes 101-103 to Mil on first error. Got some base numbers and tried to copy and paste -% from my STFTs to my VVE table. The trouble is the numbers don?t seem to be changing very much, but the graph shows other wise. Then all of a sudden the numbers start to change and get further from 0. So I left it alone slept on it got up did a data log and the numbers were reasonable a couple spots needed ironing out which I tried and not much seemed to change. Does this take a while to change? Also I noticed with the same tune loaded I got vastly different results on my STFT table. I also don?t know how to paste pictures or send a tune to show what?s going on. Any help would be great. Thanks