Hello all this is how I did it. Not a pro so not labeled as "how-to." This was done after installing https://www.deatschwerks.com/18u-00-0078-8. Their injector tuning data is available on their website https://www.deatschwerks.com/ford-calibration-summaries. I selected my engine type/year and injector model https://www.deatschwerks.com/sites/w...-%2018U-78.xls.
Most of this is copy any paste however make sure the units are the same. Also notice DW refers to High slope while ford lists this as High flow (opposite relationship from stock tune, stock Flow Rate Low was a higher number and vice-versa)
For the rest of these just know you can click on the unit type i.e.Volts and change the preset points.
Hope this helps someone out there.pressure2.jpgvoltage.jpghigh slope.jpgbreakpoint.jpgvoltage2.jpglow slope.jpgbreakpoint2.jpgpressure.jpgmultiplier.jpg