Is there a way to make sure the knock sensors are working?
Is there a way to make sure the knock sensors are working?
Smack the block/oil pan with a rubber mallet or something.
2016 Silverado CCSB 5.3/6L80e, not as slow but still heavy.
If you don't post your tune and logs when you have questions you aren't helping yourself.
seriously? ok would you happen to know where the sensors are located on a 08 4.8 Silverado. under intake?
They are located just above the oil pan on the block on both sides of the engine.
2016 Silverado CCSB 5.3/6L80e, not as slow but still heavy.
If you don't post your tune and logs when you have questions you aren't helping yourself.
thanks, the e38 ecm doesn't show a "sensor" it has knock retard (plane angle). is this the right pid to log?
It should just be a regular knock retard channel you can log.
Re-poll for supported parameters while connected to the vehicle if you haven't.
2016 Silverado CCSB 5.3/6L80e, not as slow but still heavy.
If you don't post your tune and logs when you have questions you aren't helping yourself.
thanks for the info.