Results 1 to 2 of 2

Thread: 2020 GT500 Support

  1. #1
    HPT Employee Eric@HPTuners's Avatar
    Join Date
    Oct 2007
    Location
    Crawfordville, FL
    Posts
    2,409

    2020 GT500 Support

    A lot of you have asked to see the new GT500 file. Here you go.

    The TCM for the DCT is still being worked on.

    Regards,

    Eric Brooks
    HP Tuners
    Attached Files Attached Files
    Eric Brooks
    HP Tuners, LLC

  2. #2
    Is it normal to require connection to the MPVI2 every time you open it?

    Also noticed a couple of the mapped point tables were bottom up versus top down. One had the axis populated with ???.

    My Whipple calibration uses valve events in 360 degree range, this looks to use 720 degrees for the full cycle, is that just due to the calibration?