BF ZF6 Speed to TH400 No data logging when trans removed
G'day fellas,
I have got a 2005 bf xr6t that was a factory zf car i have now put a turbo 400 in it and when i have gone to change it from a auto to manual in the trans section of the tune i loose the data logging in the vcm scanner.
When i plug the trans back into the loom and select enable on the trans in the tune everything works as it should
When i unplug the trans but leave it as auto in the tune the data logging works but the car wont rev over 1500rpm.
If i unplug the trans and disable the auto in the tune the car will rev and drive all ok but i have no data logging. I have a O2 sensor wired into the side of the mpvi pro and it will log regardless of what the rest of the car is doing..
Was just wondering if anyone else had come across this issue before and could give me some advise.
Also if anyone has a BF XR6T manual tune I could get a copy of it would be greatly appreciated.
I have got a BF manual tune and flashed it into my car and now the car will start, rev, data log and work as it should but i have a oil pressure light and traction control/abs lights. I scanned the car and it has codes as follows:
P0520 Engine oil pressure sensor/switch circuit malfunction
P0801 Reverse inhibit control circuit malfunction
I have looked at the wiring diagram for this car and it seems that the oil pressure sensor is the same pin out on both manual and auto. Im not sure about the reverse but im not to stressed with it. Has anyone seen this before?
I believe joining the 2 canbus circuits at the trans plug and bridging the N start wire will allow you to select manual and just turn off the MIL for the codes.
however with no speed input you'll have to try a few things. maxing the inferred movement RPM and neutral limits is required