So I've lost a few days with this... E92 controllers
The first one was a 2014 C7, manual trans car. Another shop had installed ECS blower and tuned it. We did methanol, pullied down, long tubes; etc, The ECM is running 12665218. I get it on the dyno, I'm putzing along and BAM; 1-4 skip shift. What the heck? Min enable temp was already set to 493... and here's where I flubbed... I made a very large number of changes based on a few runs that followed that incident. Being somewhat internally-smart-assy, I went scorched earth on ALL of the skip shift criteria. I finished tuning the car but had this Reduced Engine Power message (that wasn't real!) with no code present at each cranking. Eventually I worked back through flashing it until I got the skip shift stuff back to stock and the message vanished. What?
The next one is a 2015 Silverado 1500 with OS 12664769. The truck was twin turbo, flex sensor, etc., and in the course of fine tuning fuel on the dyno, and of course at the same time as other changes (who learns??) I disable knock enrichment in the PE tab, and blam.... added another afternoon of flash-and-see to get the REP message to go away at startup.
I'm bringing it up, because a kid that I help tune out west banged his head for two days over this with a C7 before asking. Have you guys seen it anywhere else? Thanks for reading.