Results 1 to 2 of 2

Thread: Help! Can't log vane position for 2008 LMM

  1. #1
    Potential Tuner
    Join Date
    Feb 2019
    Location
    BC, Canada
    Posts
    2

    Help! Can't log vane position for 2008 LMM

    I've tried every single factory PID and none of them give me any feedback for vane position. I've tried the list, histogram and time graphs but still no data. I've also looked at every thread on the subject and even though people are having the same issue, HP Tuners has not issued a resolution? This has been a huge roadblock. The only thing I haven't tried is pulling fuses, which I didn't think would make a difference because I can scan things such as timing, rail pressure etc no problem. Any advice? Switch to Efi live?

  2. #2
    Potential Tuner
    Join Date
    Feb 2019
    Location
    BC, Canada
    Posts
    2
    UPDATE: There is no issue with HP Tuners it was merely a user error.
    Conclusion: Must have the PID listed in the channel config table for it to log anything. The timegraph and histogram just get their inputs from the channel config list so if it isn't listed there it won't be logged. Rookie mistake.