-
Tuner in Training
Power Enrichment - FA - PRatio table question. - Explanation
Hi,
I am curious as to why this table would ever have anything other than zero for a ratio below 1.00? Even the stock table has some adder values. Other boost tunes i come across have values. PRatio is MAP / Baro Pressure.
PE is triggered by the WOT Pedal Thresh voltage set (unfortunately not by MAP Pressure - which is what i prefer - aka BE (boost enrichment)).
Why would anyone ever want to command Power Enrichment with a PRatio under 1.00 ? (less than ambient air pressure in manifold. Even the stock calibration has values where I would think should be zeroed (0) out under 1.00. Is there something I am missing?
Typical table i come across:
sample .pngstock.png
Also, to confirm, when in boost, the values will merely be used from the 1.00 row. One can rescale the rows correct? but only neccesary if one wants to further enrich at a specific PRatio? Otherwise, not a big deal to just put the desired target FA on the 1.00 row when in boost?
Last edited by lsguy; 12-08-2019 at 02:38 PM.