Results 1 to 2 of 2

Thread: 08 Mustang Spanish Oak won't show datalog channels

  1. #1
    Advanced Tuner
    Join Date
    Dec 2012
    Posts
    235

    08 Mustang Spanish Oak won't show datalog channels

    So I've been trying to log this vehicle, connected to ecm, selected channels to log, but when logging, it doesn't show the channels. Only shows a couple channels like, Water temp, Intake temp, Commanded Lambda, and Throttle pos. I've tried resetting , reconnecting. Haven't had this problem with Coyote Mustangs, Dodge Challengers, any Gm vehicle. Has anybody had this issue? The engine/trans combo is in a swapped vehicle, early 50's Ford Pu.

  2. #2
    Advanced Tuner
    Join Date
    Dec 2012
    Posts
    235
    Ok, I cleared all channels in the config, and started with no channels, and selected them again, and every single channel started working in the logger. Weird, not sure why this was happening, but it works now.