hey all,
I'm currently trying to get my aem failsafe wideband to read in hptuners.
I had found a thread here and on ls1tech saying that the p59 pcm uses/used ping 55 in the blue connector for the EGR position sensor.
I've wired said pin from my gauge output, however i'm not getting a reading.
I'm using an 04 p59 pcm that didn't have EGR to begin with.(aforementioned threads said it should still work)
I'm not getting any reading from the "EGR sensor" and I THINK I've enabled the EGR.
The threads mentioned table 210, which I've setup with both items set to 0, and 250, with no difference.
egr enable table 210.png
any tips or pointers would be much appreciated.