Fellas I'm losing it here. Today I switched over to a 2 bar OS on an E38 computer. Got the maf dialed in no problem but, after making my VE table to start on I take the car for a drive and I'm rich everywhere.. no biggie, I start making some fueling corrections to the VE table and driving around some more just logging as much data as possible. Even after my first revision I noticed that the corrections I've made have had little to no effect on idle and decel, part to mid throttle adjustments are working though. After my last log I'm not sure what I'm doing wrong but after a few tune revisions the scanner is showing I need to take out as much or even more fuel at little or no throttle than when I first started. Any ideas on what I'm over looking? I took a few snap shots to kind of show you guys what I'm talking about. Screenshot (1).pngScreenshot (4).pngScreenshot (5).png