So I tuned a truck for a friend of mine. Its 100% stock other than the tune. Problem I am getting is if you floor it to pass a car on a two lane road or something it sets the wrench light and goes into a limp mode. Pull over turn the truck off start it up and take off everything is good. Basically the only things I have done in the tune is set the throttle table to allow it to go to wot at any rpm not the scaled way from stock and add about 15% in the driver demand torque tables in the higher up cells. Im away from my laptop currently and posting from my phone so I cant post the tune just yet. Also I am not getting any codes to pop up. Anybody run into this before?