-
Tuner
spanish oak and MAP
I understand that 2007-2010 gt500 also shares the same spanish oak pcm that the 05-10 gt uses. gt500 uses a MAP sensor so there should be an empty pin at i believe pin 62 of c175e connector and my ecm has a map enable/disable function on my 07 gt that may or may not open up a table with map function enabled. wondering if i wire in my gm 3bar and log it thru ecm and not my proset. Anyone have any idea if this is possible ?
-
Advanced Tuner
GT500 does not use a MAP sensor.
-
Tuner
i just looked in the wiring diagram and it appears there is a map input that is derived from the egr. wouldnt this mean map is not "inferred" if there is a feed into the pcm ?
Annotation 2020-02-04 002050.png
-
Advanced Tuner
They do have a supercharger inlet pressure sensor, but not map. The sip sensor will only measure up to atmospheric pressure, not boost, since it's in the supercharger inlet.
-
Tuner
was wondering if the ecm would support boost pressure thru that input if wired to an external 3 bar. i guess what im asking is, is there range in the ecm for lets say 300+ kpa or does the ecm still only infer map above atmospheric in this ecm ?
Last edited by sportinawoody; 02-04-2020 at 05:24 PM.