Results 1 to 4 of 4

Thread: Power enrich delay even though there shoudlnt be?

  1. #1
    Senior Tuner
    Join Date
    Jun 2004
    Location
    Baltimore, Md
    Posts
    1,204

    Power enrich delay even though there shoudlnt be?

    Can see if doesnt go into power enrich until 4100 rpm/68% pedal/148 kPa even though it should above 25% pedal?
    Attached Files Attached Files
    Factory Stock 97 SS M6 13.51 @ 104.3 mph
    Stock Longblock LS1 w/ 233/238 P.S.I. Cam
    10.81 @ 126.9 Full interior, six speed on 275 radials, a decade ago

    '99 TA trunk mounted 76mm 6 Liter
    9.0s in '09 @ 153 MPH

    Turbo 5.3 Volvo 740 Wagon
    32psi and still winding out 5th on the highway somewhere

  2. #2
    Advanced Tuner
    Join Date
    Apr 2011
    Location
    Chicago, IL
    Posts
    763
    where do you see the delay happen? during the 1st higher rpm section it hits around 50 tps % @4k which then enables PE and under that you dont go in PE because you havent met the actual tps enable %. the 2nd one hits way sooner because your tps is higher than the 1st one is at that given rpm. the PE tps enable is tps plus idle tps if i remember correctly so if you want it to happen at a lower tps enable you will have to lower the PE enable setting for tps enable. remove 10% and youll see it enter around the 40% mark probably if you repeat that first high rpm section again
    Last edited by TCSS07; 02-12-2020 at 03:50 PM.

  3. #3
    Senior Tuner
    Join Date
    Jun 2004
    Location
    Baltimore, Md
    Posts
    1,204
    Quote Originally Posted by TCSS07 View Post
    where do you see the delay happen? during the 1st higher rpm section it hits around 50 tps % @4k which then enables PE and under that you dont go in PE because you havent met the actual tps enable %. the 2nd one hits way sooner because your tps is higher than the 1st one is at that given rpm. the PE tps enable is tps plus idle tps if i remember correctly so if you want it to happen at a lower tps enable you will have to lower the PE enable setting for tps enable. remove 10% and youll see it enter around the 40% mark probably if you repeat that first high rpm section again
    I think i didnt realize I had undid me earlier PE settings in a flash revision. Seems to be a little bit better
    Attached Files Attached Files
    Factory Stock 97 SS M6 13.51 @ 104.3 mph
    Stock Longblock LS1 w/ 233/238 P.S.I. Cam
    10.81 @ 126.9 Full interior, six speed on 275 radials, a decade ago

    '99 TA trunk mounted 76mm 6 Liter
    9.0s in '09 @ 153 MPH

    Turbo 5.3 Volvo 740 Wagon
    32psi and still winding out 5th on the highway somewhere

  4. #4
    Advanced Tuner
    Join Date
    Apr 2011
    Location
    Chicago, IL
    Posts
    763
    yeah its much better this time as it went into pe around 42% instead of 50%. you'll just have to play around with the enable to get it where you want
    Last edited by TCSS07; 02-14-2020 at 07:22 AM.