Im having a lot of issues with my tune.. first off, i cant for the life of me dial in the tune telling it the correct injector size which is 80lb/hr seimens deka. i have, instead entered in 54lb/hr. that number is there because its the only one i can get to work. The issue occuring is that i have my ve table basically maxed and am comanding a lot richer than i am getting. if i command for example 7.0 afr using power enrich vs rpm it ends up about 13.5 afr but the car is very slow.. i know this sounds like a bad wideband at this point but this is the third since this issue began. It actually runs out so lean itll completely shut off after a couple seconds under boost but fuel pressure remains perfect.
My setup: 3800 series 2:kb pistons, hand ported heads, cx racing gt35 turbo, 3" exhaust fender exit, now aem wideband and glowshift narrowband sensors, aem inline fuel pump, seimens deka 80lb/hr injectors, "built" 4l60e
The troubleshooting ive done: took all hard 90's out of the fuel system, ran all 3/8 hose from the tank to rails, fuel pressure gauge reading 45psi at idle and 60psi under 10psi of boost which to my understanding is perfect, cleaned injectors and checked spray patterns, they look perfect.. tried tuning the right way adding to ve table with no results..the only thing that i can see results from is commanding extremely rich though power enrich afr vs rpm.
im open to any and all criticism, i want to learn how to tune the right way and i know some/many of my methods are not correct heres the tune file thats been the best so far. og2 first 54.hpt