Only my second post. I swapped in a 2016 6.4 from a wrecked challenger. I have everything hooked up and the truck starts and runs but is throwing a bunch of codes.
PO300 Random Misfire - I have gone through all vacuum lines exhaust and checked wiring all are good
P0052 O2 Sensor 2/1 Heater circuit high - The cats are gone but I don't have a tune to remove one of the O2 sensors - How do I do that?
P0132 O2 Sensor 1/1 Circuit High - same as above
P0032 O2 Sensor 1/1 Heater Circuit High - same as above
P2122 Accelerator Pedal Position Sensor 1 circuit low
P0750 LR Solenoid Circuit
P0846 2-4 or 2C Pressure Switch Rationality
P0935 Line pressure sensor circuit high
P0058 2/2 Heater Circuit High
P0443 Evap Purge Solenoid Circuit
The ECM is the 2013 Ram 5.7 Computer on the 6.4 motor.
Fuel Pressure 54.8
MAP 9.7
Spark adv 4.5
IAT 95 degrees
TPS% 16.5
I have attached the base tune or what the truck is running off of currently. Any suggestions or direction to get a tune to get it running correctly is greatly appreciated. Thanks in advance and stay safe.
Motor is backfiring and if I try and drive it any it goes into limp mode with the lighting bolt flashing.