Results 1 to 3 of 3

Thread: Tuning 2.3l Focus RS after catless downpipe install

  1. #1
    Potential Tuner
    Join Date
    Feb 2020
    Posts
    1

    Tuning 2.3l Focus RS after catless downpipe install

    Hello,

    I am looking for some advice on tuning my Focus RS. I have the MPVI2 and after reading the ECM i determined that the previous owner had tuned the vehicle. When I bought the car it was all stock and since then I have added a mishimoto intake and this past weekend I installed a catless downpipe. The car doesn?t seem to have any drivability issues but I would like to try to tweak the tune myself.

    Since the tune isn’t visible to me I have to start with the stock tune VCM Editor provides (previous tune is locked?).
    My question is what parameters do I need to change to make up for the lack of back pressure from the downpipe. I understand how the torque tables work and kind of what tables to edit when they are being demanded. My fear is that I will flash the car back to stock and loose all drivability and not be able to make the necessary changes. Any help would be greatly appreciated.
    Last edited by Ryanearly; 03-26-2020 at 08:10 AM.

  2. #2
    Tuner in Training
    Join Date
    Feb 2019
    Location
    Lewisville Texas
    Posts
    38
    find someone with a stock tune. i tune all these using cobbs protuner software so i dont have anything i could share for you

  3. #3
    Tuner in Training
    Join Date
    Jul 2019
    Posts
    23
    Hey Ryanearly. post your stock file and I can help, we mostly tune them in SCT however can help you out in HP.