Results 1 to 3 of 3

Thread: Need Help - AutoMeter ATM-3363 Fuel Pressure Sensor via Pro Link

  1. #1
    Potential Tuner
    Join Date
    Aug 2019
    Posts
    4

    Need Help - AutoMeter ATM-3363 Fuel Pressure Sensor via Pro Link

    Hello

    I have a 2016 Mustang GT with Whipple supercharger and I'm trying to add fuel pressure into my list of channels to data log at the track. I purchased a fuel pressure sensor and gauge (ATM-3363) which has 3 signal wires, a 12v switched power, and a ground.

    I would like to know what signal wires from the sensor I should connect to the ProLink, and whether or not the Pro Link requires a 12v power and ground? Also, I would like to know what the signal curve in volts represents in PSI of fuel pressure (e.g. I need to translate the incoming value of V to PSI).

    Please advise, thank you!
    Mario

  2. #2
    Potential Tuner
    Join Date
    Aug 2019
    Posts
    4
    I found the wiring diagram for my fuel pressure sensor below, which is helpful. I believe I need to connect the signal wire (purple) to the Pro Link - I don't know if the wire I use on the Pro Link matters? Does the Pro Link require switched 12v power and ground (red and black wires on the Pro Link) as well?

    https://www.autometer.com/media/manual/WEB-1002.pdf

  3. #3
    Advanced Tuner
    Join Date
    Feb 2019
    Location
    Owensboro, KY
    Posts
    266
    https://www.hptuners.com/pub/Pro_Link_v1.pdf no it dosent need a switched 12v just a ground.
    6.4 Whipple Diamond pistons Manley rods, Demon Plus Cam