Tuning a 2014 ram 1500 5.7l
Wrote a file to the truck, now it won?t start. Also won?t write when I try again, says ?controller init: failed?. All I was trying to do is disable mds.
ECM is a GPEC2
Also won?t read the ECM now, but will read TCM.
Any input?
2009 - SRT8 Challenger 6 speed - Kenne Bell 2.8LC - 520whp (for now)
2014 - Ram 1500 Sport
2013 - Volkswagen Touareg 3.0 TDI
2000 - Silverado 1500 - Turbo 5.3 - work In progress
Edit: I have tried disconnecting the battery.
I?ve also started a ticket with hp support
did u install an unlocked pcm?? its the two connectors hooked to ur pcm ,they look seated correctly on the pins but their not.. wiggle them on and confirm the green and blue locking tabs on the sides are all the way up ..
According to the supported vehicle list the 14 doesn?t need an unlocked pcm. It says 15+ rams. But maybe that?s my issue. It is a stock pcm
Reply With Quote