Deatschwerks Injector Data - Numbers Changing When Pasted

[danmw2003]

Can anyone tell my why, when I copy injector data, and paste it into the table, it changes the numbers? As in, the moment its pasted into the table, all the numbers get changed, and are no longer the same as what was just copied from the supplied data. Can anyone shed some light on whats happening here? Photos for reference.

Attachment 98189Attachment 98191Attachment 98190

[07GTS]

it's fine alot do that as they have to match the cell range so it goes to the closest value, its not something u will notice durin operation anyway

[danmw2003]

Same thing happens with minimum injector PW and short pulse adder. In fact, the only thing that scales correctly and doesnt change when pasted, is the injector flow vs. pressure table. So am I correct to assume, this is not a problem, and I shouldnt need to worry about this?

[07GTS]

yea dont worry about it they have been this way since they were made, the error they change is so low u would never notice it most are around 0.01 PW