Results 1 to 3 of 3

Thread: Lm7 pinout

  1. #1
    Potential Tuner
    Join Date
    Apr 2020
    Posts
    1

    Lm7 pinout

    Hi guys, I have been trying to hook my WB up for a week now, and could use some help. My lm7 doesnt have a CAN Bus, and the AEM WB I ordered, requires it. I have heard that I can tap into my egr pin, on the pcm( since my vehicle doesnt have egr). Trying to find out what exact pin number it is. It's on an 05 avalanche 5.3 4x4, p59 pcm

  2. #2
    Tuning Addict 5FDP's Avatar
    Join Date
    May 2012
    Location
    Rogers, MN
    Posts
    13,533
    Pin 55 on the blue connector would be what the EGR pintle position 5v reference circuit is.

    Try that and then enable the EGR in the calibration.
    2016 Silverado CCSB 5.3/6L80e, not as slow but still heavy.

    If you don't post your tune and logs when you have questions you aren't helping yourself.

  3. #3
    On my P59, I used pin 55 for the white wire and hooked the brown wire up to pin 41. Make sure to enable EGR on your tune and log EGR Sensor in VCM Scanner.

    Check the post I just made in this forums about analog logging with this sensor.
    Last edited by Just Chuck; 05-06-2020 at 11:26 AM.