Results 1 to 2 of 2

Thread: How to log Lambda with LC1

  1. #1
    Advanced Tuner
    Join Date
    Jul 2015
    Posts
    925

    How to log Lambda with LC1

    I'm using the MPVI2 w/ the Prolink.

    I was able to get AFR working(because I was unable to get Lambda to work). Using Logworks I changed it to 0 volts 10 AFR, 5 volts 20 and used .5 +10 in HPT

    ---------------
    I went back and re did the scaling for Lambda and apparently I typed something in wrong before.

    KOEO, it reads fine, when I start it the WB controller gets screwy and doesn't turn on. I'm going to change my power/ground wiring to the W/B and see if that fixes is.
    Last edited by Jay@HAP; 05-14-2020 at 06:35 PM.

  2. #2
    Advanced Tuner
    Join Date
    Jul 2015
    Posts
    925
    It was me.

    It works just like it should. I even got the serial WB working.

    Disregard this post. I'm an idiot apparently.