-
Tuner
Base fuel table question - spanish oak
When I change the values in the base fuel table which says it is for open loop operation there doesn't seem to be any change in my logs.
I went so far as to set it at .7 lambda. But when I log WOT "open loop" there is no change in indicated lambda. It will always reads around .880 then slowly ramps up to around .910 as the rpm increases.
Am I missing a fuel table or calculation someplace?? The only thing I can think to do at this point is change the inj slope. I am targeting around .850 but can't get it there.
MAF is dialed in. Trims are good.. I'm stuck.
EDIT: I'm using the stock widebands. Its a flex fuel car and came stock with dual widebands. I have also replaced them but the readings remain the same.
-
Tuner
Try to make the changes in the fuel base cold table.
-
Tuner
Ok I'll give that a try. Thanks!
-
Tuner
Thanks that was the right direction! Got the afr to hover around 12.75 to 12.50 using those tables so thanks for the direction!
-
Tuner
Glad to hear it worked with you