i am running a 3 bar os with a 3 bar map, removed the maf and added an iat sensor, wired in the sensor and it reads fine but i am having hard start issues everytime i reflash the ecm and its just the first time i have issues with it. once it starts one time it starts everytime on the first try. i noticed that the p0103 code doesnt come up until the second start, it used to come up immediately after the first start before but now that i have added a iat sensor it comes on the second time, i got wiring diagram and wired the sensor correctly and the maf wires are heat shrinked separately. any suggestions? and i am also just assuming its the maf code not coming on and it wanting the reference the maf on the first start after i reflash the ecm. also i should add that while it wants to start, me peddling the gas peddle does nothing, it cranks over, idles to about 600rpm sometimes, then dies all within 2-3 seconds. it just takes a few times on the initial start up to get it going. the log is just there for referance it doesnt show it when its trying to start.