Hey there. So I went ahead an installed a set up boost a pumps for my gt500. The instructions said to decrease the voltage table 1-2 volts and then tune from there.
I found the table listed Desired Voltage under fuel pump and scaled that one back 1.5v.
For data logging and fine tuning... am I basically tuning that table going forward? Is there and equation I need to come up with for voltage error?
Thanks everyone.
Last edited by Z71; 06-25-2020 at 07:43 AM.
2019 Ford Raptor Tow Rig Scarab 195 Open 250HO
2008 Shelby GT500 VMP Gen II-R (17psi), JLT 123mm CAI, Ford SCJ Monoblade Throttle Body, 56# Injectors, BoostAPumps, VMP triple pass heat exchanger (dual fan), 170* thermostat, BBK long tube headers, Dual resonators, Magnaflow Catback, LC2 Wideband, RXT clutch
To my knowledge this table is only for start up, PCM learns values as needed
Reply With Quote