Results 1 to 2 of 2

Thread: 0411 Swap, what Min Area to use?

  1. #1
    Potential Tuner
    Join Date
    Jul 2019
    Posts
    2

    0411 Swap, what Min Area to use?

    Hello, I searched high and low and was hoping someone here could shed some light on this... I just swapped an 0411 PCM into a '98 Vette and am wondering if I should leave the Airflow>Electronic Throttle>Idle>Min Area at the .2539% that is stock for the 0411 computer ('99-'04 TAC module) or change it to match what was in the '98 tune at .127%. Not sure it's a big deal either way, but I just did the upgrade due to a fried PCM, and with the "WARNING!!! Modify this table at OWN RISK. Incompatibility of this calibration with the vehicle TAC module calibration may render PCM permanently inoperable" listed on the bottom of the page, I figured I'd reach out real quick.

    Thanks in advance for any help/insight you can give.

  2. #2
    Potential Tuner
    Join Date
    Jul 2019
    Posts
    2
    Well, left with the stock '01 Z06 info and so far so good...