Results 1 to 2 of 2

Thread: values keep changeing in tables between computers

  1. #1
    Tuner in Training
    Join Date
    Jul 2020
    Location
    tn
    Posts
    40

    values keep changeing in tables between computers

    OK here goes,
    I hate programmign on my laptop
    so I do most of my programming/ changes on the desktop.. save the files on desktop
    put files on flash drive and then load them to my folder on laptop

    open laptop to view the files and WTF>.. the trans shift tables have all sorts of decimal values in them
    ( is not 9 but 9.34 and the wher ethe table hsoud start at 11 its not 9.34 so totally not right..

    not sure what the heck is goign on but now it dont trust any of my tune files right now and i don't want to spend hours trying to sort them out again.

    but this should not happen
    yes same veriosn or sopftware and vcm editor on both computers 4.6.3


    so??? anybody else seen this??

  2. #2
    Tuning Addict 5FDP's Avatar
    Join Date
    May 2012
    Location
    Rogers, MN
    Posts
    13,533
    You can alter the decimal point in the tune with ease and I see that happen alot. Just click the blue <.00 and .00> icon in the editor. That will change it from the 9 to 9.34 type deal.

    Not sure on the other part without seeing what you are talking about through screen shots.
    2016 Silverado CCSB 5.3/6L80e, not as slow but still heavy.

    If you don't post your tune and logs when you have questions you aren't helping yourself.