Hello,

I had to change the ECM of my vehicle. I got the calibration I needed from tis2web but I have the following code "P0630 - Vin not programmed or Mismatch -engine control module (ECM)".
Normally when I connect to GDS2 with the MDI2 normally it has to read the VIN number automatically but I have to enter the VIN number to be able to continue.
So I am assuming that the vin number is not programmed and because of that I am having the P0630 code.

I was wondering if I could program the VIN number with Hptunners.
If yes can you tell me also the licence I have to get please.

And sorry if I am posting this new thread in the wrong place. If so let me know were I can post it please.

Thank you.