Results 1 to 1 of 1

Thread: o2 readiness variables

  1. #1
    Tuner in Training
    Join Date
    Jun 2020
    Location
    rochester,wa
    Posts
    10

    o2 readiness variables

    I am using a 2002 6.0/4l80e base os, with the 3bar rtt sd on it, i segment swapped in a 4.8l in, its supposed to be a 4.8 with a 4l80e at the end of the day, i built a fuel table like the instructions said (i copied everything under atmosphere and pasted and built the rest of the table calculated roughly from my 4.8 table) when I was setting up the tune I noticed the o2 readiness voltage under the engine-fuel-o2sensors was not there.

    i have seen it under other tunes. Is it gone because they assume you will run a wideband? I have a wideband, i also have the nb sensors and was planning on figuring this out n/a on SD before I added the turbo

    or is something wrong with my segments or os, i can start over, im just trying to figure this out.
    Attached Files Attached Files