-
Tuner in Training
Importing Injector Data
Hey All, I'm fairly new to tuning. This is my first post, cause I haven't been able to find a thread on it.
Just rebuilt a 5.3.. It's now a 5.8, with new injectors. E38 ecu, 2009 Silverado.
I've been going back and forth between MAF and SD tuning, and I am getting inconsistent logs. Also, when I put everything together and run normal, the ecu pulls 18% on the LTFTs, even though that causes it to run lean according to my wideband. (LTFTs have been reset)
Anyway, I am guessing this may be due to incorrect injector data. All I did was bump my flow rate up, till it was in the range for 42lb injectors- for now.
I cannot figure out how to read this data sheet that DW gave me, and how to plug the numbers into HPTuners.
Could anyone help me understand this thing? Thanks!
DWInjectorData.jpgFlowrate1.jpg
-
Tuner in Training
Found better data I think..Hafta look at it later on the laptop.
https://www.deatschwerks.com/gm-calibration-data?
-
Tuner in Training
That data plugged right in... still having issues with O2 sensors reading richer than the wideband, but that is probably best for another thread if I can't find the answer.