Throttle response urgent

[Varto20]

What tables control the throttle response in hp tuners I thought it was these tables under airflow >electronic throttle map a normal and map b ,tow mode.....etc since these are basically an airflow tables I thought increasing the whole table by 0.5-0.10 would allow me to get a better throttle response but allot of people disagreed and said that I wasn't supposed to touch these tables without explaining why and didn't provide any alternative ways for better throttle response ,by the way I posted the same topic at gen3 forums and no body seemed to answer so I thought maybe tuners on GEn 4 platforms can help .thanks

[RobZL1]

Those are the right tables. You just have to add a little, not a lot, and not the whole table. You just want to look at the ramp-in at the "bottom" of the curve.
Gen3 would brick the ECM if you monkeyed too much. Gen4 will just send you to REP. Many threads on this here. One of the best examples for you, from my friend, The Google:

https://forum.hptuners.com/showthrea...ponse-Try-this

[Varto20]

Those are the right tables. You just have to add a little, not a lot, and not the whole table. You just want to look at the ramp-in at the "bottom" of the curve.
Gen3 would brick the ECM if you monkeyed too much. Gen4 will just send you to REP. Many threads on this here. One of the best examples for you, from my friend, The Google:

https://forum.hptuners.com/showthrea...ponse-Try-this

Thanks you.very much