Results 1 to 5 of 5

Thread: VE table goes flat after I calculate coefficients

  1. #1
    Advanced Tuner
    Join Date
    Apr 2017
    Posts
    311

    VE table goes flat after I calculate coefficients

    Trying to get my VE dailed in WOT. I'm so close to having it dialed in.

    But

    Now when I copy my Error from the VCM scanner into the VE table it looks fine. But as soon as I push the calculate coefficients button the whole 3d graph goes flat.


    What am I doing wrong now.

    11-10-20 1.hpl11-10-20 ve 2.hpt

  2. #2
    Advanced Tuner
    Join Date
    Apr 2017
    Posts
    311
    I guessing it's a zone boundary problem?

  3. #3
    Advanced Tuner
    Join Date
    Apr 2017
    Posts
    311
    yep copied and pasted in-between the boundaries then calculated and every thing worked out. Had to watch a Goat Rope video to figure it out LOL.

  4. #4
    Advanced Tuner
    Join Date
    Apr 2017
    Posts
    311
    Ok I'm bringing this back up because it's doing it to me again. I'm trying to richen up the WOT area's. So in one zone I'll try to add 4% so I select only in the zone I'm working on then multiply it by 1.04 and my 3D graph looks fine. Then I hit calculate coefficients and the numbers go off the chart and mess up the whole graph. I'm lost and don't know what I'm doing wrong.

  5. #5
    Advanced Tuner
    Join Date
    Apr 2017
    Posts
    311
    I think if I multiply by 1.04 then smooth it out a few cells up. Then hit the calculate coefficients button it will work. I loaded the tune on to my computer here at work just to play around with it. I'll go out and try it on my laptop in the truck after work.