Question,
setting up my new sensor in the scanner, i have installed and setup my AFR500v2 unit to the prolink on the 1st channel, i setup that part, an working on the transform selector.
the HP data provide has the aft500v2 wide pre set.. an function states V/.3571428 + 6 = output.
the ballenger tuning book.. states lambda (.618 - 1.098) = 0.618 + vout x 0.096
Is the setting correct pre loaded? i have this unit set for lambda..
and when i go to edit the parameter section for the chart/time, is there a change or specials unit already loaded for this as well.
Thank you in advance
-leo