New Guy - Scanner Not Logging RPM

[Deanfly64]

Hello all,
Brand new to this site and HP Tuners. As per my sig, I have a 4.0L Stroked to a 4.7L, which is running on the stock ECM tune.
Although it runs with no issues, there should be gains to be had by optimizing I would think.
As the title states, I cannot get the RPM to log. I searched the issue on previous threads, but couldn't get it to work.
I am attaching files requested my mowton in the sticky on scanner help. The Charts and Graphs folders were empty.
On the TJ No RPM 11-27-20 log, it was in park and just revving the engine. On the TJ Log 3 WOT file, it was two runs at WOT.
In the Channel configuration, if I load SAE defaults, nothing will log. I have to load Vehicle defaults for any logging to occur.
As far as Jeep TJs go, it's a beast.
Anyone that can help cure my ignorance, and get me going, it would be much appreciated.

Jeep TJ Stock Tune 11-24-20.hptTJ Channel Config 11-27-20.Channels.xmlTJ Log 3 WOT.hplTJ No RPM 11-27-20.hpl

[Deanfly64]

Any help would be appreciated!
Bill??

[5FDP]

The only thing I can suggest is that you connect to the vehicle, remove the channel completely from the list, then click the vehicle tab at the top, scroll down to re-poll for supported parameters and add the channel back in.

If that doesn't work then you will need more help from support.

[Deanfly64]

Thank you for the input. I will try after work and let you know.

[Deanfly64]

5FDP,
No joy. I have submitted a ticket on this issue.
Thanks for trying to help though!

[BBR]

Just went through this on our JTEC 1998 Durango.

In the scanner click on the File folder with a gear (Recent Channel Configs) and use Vehicle Defaults.

Click the Add Channel icon and add the high resolution rpm channel.

[Deanfly64]

BBR,
That did it (along with downloading the Beta version of the scanner per tech support.
Thanks for the assist!