Results 1 to 4 of 4

Thread: NAG1 manual stick

  1. #1
    Tuner in Training
    Join Date
    Dec 2020
    Posts
    16

    NAG1 manual stick

    Hi,
    I had predator and when I choosed mode 1 in manual shift mode I was able to select each gear. When I switched to manual selector at stop I've seen [1] and it stays at 1st till I pushed lever to + only downshifting was performed automatically by TCM. How to set the same in VCM Editor?
    300C '06 AWD 5.7

  2. #2
    Tuner in Training
    Join Date
    Oct 2020
    Posts
    25
    can you attach the stock file ?

  3. #3
    i still do it by diablo when i need too cause i couldnt figure it by vcm lool

  4. #4
    Tuner in Training
    Join Date
    Oct 2018
    Posts
    33
    You could do that by disabling the auto up-shit at WOT but keep the Auto-stick enabled that should do it how ever when i did that using the stock TCM that did not work but later on i fried my TCM so i had to replace it with a new (stock but deferent manufacturer ) TCM it worked from what i understand the old TCM were hardwired so it can?t be changed but i can?t conform that all i no is only after i changed my TCM i was able to change anything i want without any issues
    Best of Luck