Hey Guys.
New to the site and a newb tuning.
Have read tons of info and watching lots of vids.
Been involved with tinkering and building old school cars for years but hear is my question for you guys.
Want to tune a 3.6 lfx di motor that's running about 8psi of boost and also running a wideband and want to do maf tuning on it.
In order to run on maf only to tune do I disable, decel fuel cut off enable and disable, COT disable,
O2 Readness to negitive, Dynamic Airflow high RPM Disable and Reenable and back off timing 5 degrees.
Im guessing this is probably close to GenV setup.
Any thoughts and input would be greatly appreciated?.
Thx's

BTW I have EQ Error in my histograms setup if that helps