GPI VVT SS2 BARO Tables

[rkuper82]

I have the base Variable Valve Timing table from GPI but the actual table is to blurry to read.
https://w6q4b2d9.rocketcdn.me/wp-con...ttings-L99.pdf
The instructions say to 0 out the table up to 5200RPM then start at 1 degree and "stair step" up to 6800 I am wondering if it is saying I should interoperate the remaining table? Like in my attachment?

It also mentions to Raise the High RMP Disable and Re-Enable RPMs so I assume i need to set those to 8K

VVT.PNG

[Zeroema]

Hello,

This is the picture of How Baro should be setup. This picture was share by GPI team.

Regards.

VVT Setup.png

[Zeroema]

About the rpm it doesn?t say to raise to 8000 rpm. I says 7200 rpm and 7400 rpm. Be careful