Hey Guys,
I'm in the process of installing a Texas Speed Cam with a locked phaser. Does the PCM look for timing from the lockpin tables if the phaser is locked out?
Hey Guys,
I'm in the process of installing a Texas Speed Cam with a locked phaser. Does the PCM look for timing from the lockpin tables if the phaser is locked out?
I'm not sure but alot of people just make all the timing tables the same.
Will need to validate that, but my understanding is the PCM won't know the cam isn't moving so it will still be sending the signals from looking at the VVT tables and telling the engine what to do based on those tables. It's best to set the sweep to just a few degrees within the phase limiter. Sounds like you actually locked it out, I would think you would need to lockpin to match the lockout... I'm just getting into VVT tuning so not expert, but from what I know to this point that's the input I can provide.
The PCM knows when the cam moves.
If in doubt, multiply everything by 1.1.
A good tune will not ask it to go where it can't.
If in doubt, multiply everything by 1.1.