Results 1 to 4 of 4

Thread: Needing help to get aem 30-0334 to showup in pid list

  1. 01-26-2021 #1
    Tracin1978
    Tracin1978 is offline
    Tuner in Training
    Join Date
    Jun 2019
    Posts
    10

    Needing help to get aem 30-0334 to showup in pid list

    I can't find it in the channels list anymore. I haven't use the gauge in awhile to tune with.
    Reply With Quote Reply With Quote
  2. 01-26-2021 #2
    hjtrbo
    hjtrbo is offline
    Senior Tuner
    Join Date
    Jul 2020
    Location
    VIC Australia
    Posts
    1,140
    Try this. When connected and with the wideband running from the scanner menu, select repoll parameters.
    Reply With Quote Reply With Quote
  3. 02-03-2021 #3
    SteelGreenStallion
    SteelGreenStallion is offline
    Tuner
    Join Date
    Nov 2014
    Location
    Utah
    Posts
    60
    Did you configure it in the add-on I/O's? There's already a Configuration for AEM in the list you just have to select it.
    Reply With Quote Reply With Quote
  4. 02-04-2021 #4
    dr.mike
    dr.mike is offline
    Advanced Tuner
    Join Date
    Dec 2005
    Location
    Posts
    604
    1st thing is to make sure that you actually have a proper 30-0334. A while back there was a batch of 30-0334s that were shipped out with 30-0300 firmware.
    These can be distinguished from the normal 30-0334s by checking the menu on the gauges.

    The 30-0334 will have a menu item listed as "Obd2". The 30-0300 has "CAn" in its place. If you gauge has the "CAn" menu item, contact AEM for a replacement. They know about this issue.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »