I'm was told when I change anything in the system options I need to write entire. Is this true or can I write calibration only after changing 1 to 0 under brake torque management on 2004 p59 pcm
I'm was told when I change anything in the system options I need to write entire. Is this true or can I write calibration only after changing 1 to 0 under brake torque management on 2004 p59 pcm
No. System Options is just a table in the calibration on Gen3 PCMs. There is a System Tab in Gen 4 ECMs that require Write Entire when they are changed.
Reply With Quote