VVE MAP / Baro Pressure Ratio Logging Help

[seamore]

So i am having trouble logging for my VVE table to dial in my tune as i have MAF disabled to dial it in.

Named it Pressure Ratio
My math parameter is [50030.90]/[50032.90]

50030 MAP sensor Unit Pa
50032 Barometric Pressure Unit Pa

My graph is setup as:
EQ Ratio Error [Math] (from lambda & AFR table )
Unit: %
Decimals: 2
Cell Hits: 3
Shading: 20 High 0 Low
Column Axis: Engine speed
Unit: RPM
Row Axis: Pressure Ratio
Unit: (blank)

I have copy and pasted both axis from the VVE table but my cells are all blank when trying to data log. Please HELP!
Also doing this on an ATS-V

[lVloses]

So i am having trouble logging for my VVE table to dial in my tune as i have MAF disabled to dial it in.

Named it Pressure Ratio
My math parameter is [50030.90]/[50032.90]

50030 MAP sensor Unit Pa
50032 Barometric Pressure Unit Pa

My graph is setup as:
EQ Ratio Error [Math] (from lambda & AFR table )
Unit: %
Decimals: 2
Cell Hits: 3
Shading: 20 High 0 Low
Column Axis: Engine speed
Unit: RPM
Row Axis: Pressure Ratio
Unit: (blank)

I have copy and pasted both axis from the VVE table but my cells are all blank when trying to data log. Please HELP!
Also doing this on an ATS-V

Do you have Engine RPM, MAP, Baro, Wideband, and commanded AFR (or whatever unit you?re using) all in the channels list?

[seamore]

Yeah, which is why i am just not understanding why it's not logging. Was hoping i overlooked something easy.